Hello, welcome to the official website of Guangzhou Zhengying Titanium Products Co.Ltd!

PRODUCT SHOWCASE

IMG_20230704_175219
IMG_20210308_093712
IMG_9057
IMG_8869
IMG_8891
1b1ee67db4a8e51163e70b56af4fb3b
IMG_20191116_163644
wx_camera_1584168972164
4
1
1a2da35fb7750831cfb81a99927405f
IMG_8018
IMG_7698
IMG_8918

Titanium Square Blue

IMG_20230704_175219
IMG_20210308_093712
IMG_9057
IMG_8869
IMG_8891
1b1ee67db4a8e51163e70b56af4fb3b
IMG_20191116_163644
wx_camera_1584168972164
4
1
1a2da35fb7750831cfb81a99927405f
IMG_8018
IMG_7698
IMG_8918
Product Description

Product Characteristics

  1.  Can effectively control the ratio of anode and cathode.
  2.  Good solubility of anode, less anode sludge.
  3.  Easy to replenish and load/unload anode materials.
  4.  Safe use of anode material, saving energy consumption.

Usage

  1. The conductivity of titanium is poor, generally the hook outside the water is energized with a current of not more than 0.26A/m ㎡, and the hook in the water is energized with a current of not more than 1.5A/m ㎡, otherwise the hook body will heat up, resulting in the liquid temperature rising, the refrigeration capacity increasing, wasting electricity, and even damaging the plastic tank body due to the heat generation. Found that the hook body is obviously hot, can increase the number of titanium blue or increase the cross-section size of the hook to improve the conductive effect of titanium blue.
     
  2. Titanium blue hooks and electrodes generally do not use flat or round contact, because it is easy to cause poor contact, so that the electrode produces spot corrosion.
  3. Titanium blue mouth should be slightly higher than the liquid surface to prevent anode slag outflow.
  4. The lower end of the titanium blue should be higher than the plated parts 100mm~150mm, so as to avoid the lower part of the current is too concentrated, causing scorching.
  5. Titanium blue and anode should be in close contact, otherwise the anode potential on the titanium blue will rise sharply, so that the surface of titanium blue precipitation of oxygen and precipitation of chlorine reaction, resulting in damage to the titanium blue and the oxidation of additives.
  6. In order to prevent the plating layer from burrs, should be in the titanium blue outside the anode bag, because the anode bag is usually long-term use without removing, so it is recommended to use the “double bag” method. The anode bag should be wrapped tightly around the mouth of the titanium blue, leaving a gap of a few inside the bottom of the bag to store the anode mud that may be generated

 

未找到相应参数组,请于后台属性模板中添加

CONTACT INFORMATION

No.16 bis, No.1 Street, Private Industrial Zone, Fulong Road, Shawan Town, Panyu District, Guangzhou, China

OFFICIAL ACCOUNTS

Welcome to our official public number

公众号二维码

ONLINE MESSAGE

Username used for comment:
客户留言
Description:
验证码